Shop

ChromaNik SunShell C8-30

The C30 stationary phase is often used to separate structural isomers and the higher the bond density of C30, the higher the separation coefficient; but if the bond density is too high, the number of column stages will be low and tailing will occur and the degree of separation will decrease.

Since SunShell C30 is made with the optimum pore size and bond density, there is no tailing and the high number of stages due to the core-shell particles makes it possible to separate components that were difficult until now.

SunShell C8-30 Ordering Information

Inner diameter (mm) Length (mm) SunShell C8-30, 2.6μm


Catalog no.

USP category
2.1 50
100
150
IUC36941
IUC36961
IUC36971
 L7
3.0 50
100
150
IUC36341
IUC36361
IUC36371
L7
4.6 50
100
150
IUC36441
IUC36461
IUC36471
L7
Clear
SKU: N/A Categories: , , , Tags: , , , , , ,
Description

SunShell C8-30

SunShell column not only has an inert surface, but also high stability due to deactivated silanol groups. SunShell 2.6 μm column can be used on both HPLC and UHPLC because it shows 2 times lower back pressure than the sub 2 μm column.
SunShell C18 2.6 μm sized 100 x 4.6mm has the same performance as a totally porous C18 5 μm sized 250 x 4.6mm so that the same separation can be achieved by both columns without changing the separation condition. Consequently, analysis time is reduced by one-third.

Additional Information
Particle Size

2.6µm

Length

50mm, 100mm, 150mm

Internal Diameter

2.1mm, 3.0mm, 4.6mm

Pore Size

300Å